Code: F19🧺 Hotpoint Washer

Hotpoint Washer Dryer F19 Error Code: Fan Motor or Heating Fault

Reviewed 2026-10-26 · Based on 2 manufacturer & service sources

What the code means

Hotpoint UK's washer dryer error code guide lists F19 as "Fan motor or heating fault (washer dryers only)", with the symptom that the washer dryer is not drying or stops during the drying cycle, and its only advice is to call Hotpoint on 0344 822 4224 to book an engineer. Hotpoint's washing machine guide has no F19, because plain washers have no drying fan or drying heater. In other words, F19 sits in the drying circuit: a washer dryer dries by blowing air over a separate drying heater with a fan, and F19 means the electronics found a problem with that fan or that heating. Hotpoint doesn't publish a component-level test for F19, so the specific checks are for an engineer. The neighbouring drying codes on the same list help narrow it down: F13 is a dryer temperature sensing fault (the drying sensor) and F15 is a heater control fault that can stop drying or washing. If your display shows F19 and the machine also won't heat water on a wash, mention that to the engineer, as it points to a wider heating problem.

Likely causes

Safe DIY checks

⚠ Before you start

Unplug the appliance (or switch off its breaker) and shut off the water supply valves before removing panels or disconnecting hoses. Keep towels handy for residual water.

  1. Note when it happens: does F19 appear only on drying programmes, or also on wash-only programmes? That tells the engineer where to start.
  2. Run a wash-only programme. If the machine washes normally, you can keep using it to wash and air-dry clothes until it's repaired.
  3. Switch the machine off and unplug it for a couple of minutes, then try a drying programme again. This is general advice for clearing a one-off glitch, not a Hotpoint step for F19.
  4. Don't overload the drum on drying programmes and check the load is within the drying limit in your manual; this won't fix a failed part but avoids drying stalls being mistaken for faults.
  5. If F19 comes back, stop there and book an engineer: the fan and heater are inside the machine on mains voltage.

🛠 When to call a pro

  • F19 returns after a power reset: Hotpoint's only listed fix is an engineer visit.
  • You smell burning or see scorching near the top or back of the machine during drying: unplug it and don't use the drying function until it's checked.
  • The machine also won't heat on wash programmes, which suggests a wider heating or board fault.
  • The washer dryer is under warranty: call Hotpoint service on 0344 822 4224 rather than opening it up.

Parts that commonly fix it

Always match the part number to your exact model.

⚙

Hotpoint washer dryer drying fan motor

One of the two parts named in Hotpoint's F19 description. Match it to the model number on the label inside the door.

Search eBay →
⚙

Hotpoint washer dryer drying heater element

The heating side of F19. Only replace it once a test confirms it has failed.

Search eBay →
⚙

Multimeter

For continuity checks on the heater and fan with the machine unplugged.

Search eBay →

Sources

  1. Hotpoint UK: Washer Dryer Error Codes (F19 fan motor or heating fault, washer dryers only; not drying or stops during drying cycle; book an engineer on 0344 822 4224; F13 dryer temperature sensing and F15 heater control for contrast)
  2. Hotpoint UK: Washing Machine Error Codes (plain washing machine list, no F19)

Last reviewed 2026-10-26. Always confirm against the manual for your exact model number.